How To Install Laminated Floor Over Concrete Floor

A container for solution.

How to install laminated floor over concrete floor.

Installing click lock vinyl plank flooring is very similar to laminate flooring. Leave the flooring in the room for three days before installation. The thinner construction of this type of vinyl plank should be taken into account if you are planning to add a foam underlayment. Work with great care otherwise you might scratch the jambs.

Then nail the flooring planks with a standard flooring nailer see photo for details. It will add less than 3 4 in. Allow the thinset to completely dry before you seal the. This will help to acclimate the flooring to the room temperatures and humidity.

Height change is too much consider laying a laminated wood floor instead. Although it is possible to lay laminate flooring over an existing concrete floor there are a few things that will need to be done beforehand to ensure that the surface is going to be suitable. Lay the 1x4s perpendicular to the direction you intend to install the floor planks. Clean the concrete surface and apply a thinset compound to all of the low areas until the surface of the concrete pad is smooth and level.

Place a piece of underlay on the concrete sub floor and a laminate board on top. If the 1 1 2 in. Installing laminate flooring on concrete steps if you ve got concrete stairs to cover the laminate must be glued down using high quality construction glue. Place the laminate flooring on the concrete slab in the room where it is to be installed.

To prepare the foundation concrete floor for laying laminate you will need. Fix concrete subfloors with a patching compound and for wood subfloors remove protruding nails and replace any damaged boards. Next use a back saw to cut the wooden door jamb by holding it perfectly level. You will need to ensure that the concrete floor you are laying the laminate on is as smooth and even as possible.

Laminate flooring is ready to install as long as the base floor is clean and smooth. After removing the existing flooring baseboards and quarter moulding check that the subfloor is solid flat and clean. A plastic roller with spikes. To determine the roughness of the concrete floor we put a direct rail to the floor and a level is determined at any not very smooth place.