Hanging fringed rug on wall hanging fringed rug on wall.
How to hang a rug with fringe on the wall.
Hot glue a strip of the cotton fringe right along the long bottom edge of your rug.
To protect your rug from the wood and nails paint or seal the rug strip and let it dry completely.
Repeat until the entire rug is covered in fringe.
Insert a suitable rod.
Pass a bar through the strip and hang the rug.
Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug.
This method allows you to hang a fringed rug on the wall without damaging it.
Next stretch it out left and right and place additional push pins there.
This will serve as casing for your rod when hanging the rug.
Cut a piece of fabric the same width of your rug large enough to be able to form a tube that will snuggly fit the width of your rod.
Hot glue another strip about 1 2 to 1 depending on how dense you want the fringe to be above the last.
Sew muslin to the top of the rug.
Then pin the bottom.
Attach the tape to the back of the rug in the same way as for a smaller rug.
Sew fabric to the top of the rug forming a tube.
Attach anchors to the wall using a drill and screws.
Insert rod into the tube of fabric on the rug and hang the rod onto the wall.
For extra support hammer nails into the corners.
Line up the carpet tack strips where you ll want to hang the rug and gently hammer the nails into the wall.
This method allows you to hang a fringed rug on the wall without damaging it.
Using a level to ensure the strip is entirely straight attach the piece to the wall using nails or screws.
Attach rod support the brackets to the wall aligned with the gaps in the.
First cut the tape into 12 inch sections and attach the sections to the rug 1 2 inch apart.
To hang a round rug on the wall you would use push pins or command strips.
First mark where you want the rug.
Put the top of the rug there and put a push pin or command strip there.
The second method of hanging a rug should be used for large and heavy weight rugs.
Knot a decorative c.
The second method of hanging an area rug on the wall involves the use of a curtain rod.
Since you ve already measured your carpet tacks to the length of your rug you ll want to place the strip where the top of the rug will sit on your wall.
Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug.
Now add your contrasting fringe.
This should be attached close to the top of the rug.
Cut a few small strips and lay them on top to decide where you want them.
Hanging fringed rug on wall.
These gaps permit the use of additional brackets and prevent sagging.
