How To Grade A Foundation Floor

In some cases additional footings often a thickened slab are necessary under bearing walls or columns in the center of the slab.

How to grade a foundation floor.

2009 concrete and masonry foundation walls shall extend above the finished grade adjacent to the foundation at all points a minimum of 4 inches 102 mm where masonry veneer is used and a minimum of 6 inches 152 mm. The foundation wall may be an integral part of the load bearing design of the building carrying column and floor loads from above either as distributed loads on the wall or point loads on pilasters integral to the wall system. Figure 4 15 illustrates a slab on grade with an integral grade beam. If the building site has problematic soil such as expansive clays a raised floor foundation would perform much better than slab as slab would most likely crack on this type of soil.

The grade beam sits on a footing which provides support for the brick cladding. Generally it is the siding that should be above the grade not the finished floor. A good builder determines the highest point of ground near the home and sets the top of the foundation in relation to this high point. The word grade references the level of all the ground on your building lot before you start to dig a hole for the foundation.

And drainage elements to the exterior of below grade foundation walls a slip plane should be introduced. Concrete masonry is well suited for below grade applications because of its strength durability economy and resistance to fire insects and noise. A raised floor foundation has many pros and fits most project applications. The major structural components of a slab on grade foundation are the floor slab itself and either grade beams or foundation walls with footings at the perimeter of the slab see figures 4 2 and 4 3.

A raised floor is also used to raise the building above a floodplain. The slope of the finished grade must be maintained at a minimum of 6 inches of fall within 10 feet. R404 1 6 height above finished grade. Foam insulation runs on the inside face of the airspace behind the brick.

The foundation insulation is in the same plane and is applied to the slab edge below the termite shield down to the footing.