Once the seal ring is in place re fit the spout and secure it and you re done.
How to fix a dripping ceramic mixer tap.
Photo 4 shows the same tap valve with the discs closed meaning the tap would be off.
Small flat head screwdriver.
How to fix it.
Want to find out how to fix a dripping tap.
Allen wrench screwdriver groove joint pliers an old toothbrush and a replacement cartridge if needed.
Carefully remove the ceramic cartridges take note of which is for the hot tap and which is cold.
Turn off the water supply avoid making a mess by turning off the water.
If the ceramic cartridges are worn replace with identical parts suitable for the tap unit.
You can either do this at the stopcock or isolation valve which is located on the pipes underneath the sink.
2mm allen key hex key access to the water shut off valve.
Locate your stop tap so that you can turn off the hot and cold water supply to the house.
Tools you ll need to fix a dripping monobloc tap.
Ceramic tap valve with disc closed.
Drop it back down inside the neck of the tap and make sure it sits neatly at the base.
1 turn off the water at the valve under the sink and turn on the faucet until the water stops running.
In today s video i will be showing you how i repaired my 8 year old kitchen tap mixer and dripping tap.
Remove the red and blue indicator.
A box of washers in the form of a plumbers repair kit can be bought from most plumbers merchants or your local diy store.
Use your allen key to undo the grub screw until you can lift the handle off the cartridge spindle.
What is wrong with it.
If you love my content and would like to send me a co.
Then this tutorial can help showing you how to replace to a ceramic disc tap.
If you have a more modern tap that has a ceramic cartridge skip this bit and move onto the section labeled how to change washer on mixer tap below.
The grub screw sizes vary tap to tap but a 2mm or 2 5mm allen key generally does the job.
This screw is what fixes your handle to the base of your mixer tap.
Check both cartridges for dirt and damage.
Two locating lugs fit into the top part of the top disc and turn with the spindle.
The ceramic discs are in two parts and it is the top part which moves over the bottom part.
If the cartridges are dirty wipe clean with a damp cloth and dry thoroughly.
Be sure to drain all the water from the pipes to prevent a mess.
For loads more how to videos head.
I have a couple of taps that do this.
Why does it do this.
